5-8T/H Dry mortar wall plaster powder machine dry mortar production
line
Description:
The semi-automatic dry mortar equipment is a dry mortar equipment,
which is made of high-quality steel plate. The internal mixing
system is a double fixed fan-shaped stirring blade and can be
replaced. It is mandatory to stir during work, and there is no dead
angle in the working cabin, which realizes the uniform dispersion
of various fibers and additives in the mortar. The device is easy
to operate. Easy to master. It adopts one-way feeding and lifting,
does not need basic fixing, low noise, and can be equipped with
pulse dust collector. It can not only recover the materials lost by
dust, but also purify the working environment. It is an
environmentally-friendly dry mortar mixing equipment selected by
medium-sized building materials enterprises.
Parameter about mixer:
| Model | capacity(t/h) | total power | hight | man power | mixer volume | occupied area |
| semi-auto dry mortar plant | 5-8 | 20-30kw | 6-8m | 3 workers | 2m3 | 50-60m2 |
Semi automatic dry mortar plant can produce following dry mortar:
Bonding mortar: such as tile adhesive, caulking agent, special
bonding mortar for thermal insulation composite system; plastering
mortar: such as interior and exterior wall plastering, putty, color
decorative mortar, thermal insulation mortar, etc.; masonry Mortar:
such as ordinary masonry mortar, concrete bed special thin bed
mortar, thermal insulation masonry mortar; floor mortar: such as
ordinary floor mortar, self-leveling mortar, etc.; special mortar:
such as repair mortar, waterproof mortar, hardened powder, etc. ;
compound admixtures: such as anti-cracking agents, expansion
agents, early strength agents.
Production line operation guide:
1. Read the instructions carefully before starting up. Confirm that
the direction of rotation of the motor such as hoist, mixer, pulse
dust collector and valve mouth scale is correct. Check whether the
switch button of the pneumatic valve of the mixer is misaligned,
whether there is any foreign matter in the warehouse, and the
production can be started without confirmation.
Note: If the motor of the valve port filler is rotated in the wrong
direction, it will not be packed properly.
2. Start the first step. First turn on the main control switch of
the control cabinet to turn on the computer system, preheat it for
ten minutes, turn on the air compressor to raise the air pressure
to the rated air pressure, and then add the ingredients ratio
(recipe) of various raw materials. , (semi-automatic model) The
first batch of materials is completed, the operator needs to open
the metering conveyor button to make the raw materials enter the
mixer through the bucket elevator to mix, and the mixing time of
2-3 minutes can reach the uniform requirement to start mixing. The
machine discharge button is discharged to the finished product
warehouse, and the operation is repeated. It must be noted that
each batch is completely in the next step before the second step
can be performed.
Note: If the raw material with a large specific gravity such as
quartz sand is put into the inlet of the hoist, it should be
gradual and cannot be slammed in order to avoid jamming the hoist.
Installation site:
Packaging and delivery:
